Tuesday, June 26, 2018
Kadee Scale Head Whisker Couplers for the Austrains KP and LHO
Kadee Scale Head Whisker Couplers for the Austrains KP and LHO
During the operating session on Bylong last week the Austrains KP Mail Van had issues with a low coupler, this post describes the resolution of that issue and how I had originally mounted Kadee No. 153 Short Scale Head Whisker couplers to replace the very long supplied couplers. Please note that the minimum radius curve on Bylong is 762mm (30").
The process of replacing the couplers had me scratching my head until I worked out the following:
1. Remove the supplied couplers.
2. Drill a hole of a size suitable for a small coupler mounting screw, hard up against the small rear wall of the coupler box on the van floor.
3. Cut off the small rear wall of the coupler box as per the photo.
4. Carefully cut away the coupler mounting bush from the coupler box (see photo below).
5. Now you need some coupler bushing adaptors from Kadee 20 Series couplers, you are going to use the larger of the small plastic bushes.
6. Assemble the coupler into the box with the bush in the pivot hole of the coupler and screw the lid on.
?
Kadee 20 Series Adaptor Bushes
?
Now, the coupler box seems to be a little deep which may help the coupler to droop a little so a 3mm washer needs to be placed on each bogie mounting to raise the van slighty. Adjust the coupler pin with pliers if necessary.
I suspect that the van might be a little low as it now seems to align better to other passenger cars but I have not checked any dimensions.
The Austrains LHO can be similarly modified but it seems to need 1/8" washers as the central post of the bogie mounting is fractionally larger in diameter than the KP.
